K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Wiper Motor: Service and Repair
Wiper Motor Replacement
REMOVAL PROCEDURE
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Disconnect the electrical connector from the motor.
IMPORTANT: Do not remove the crank arm.
4. Loosen the nuts attaching the drive link brackets to the crank arm.
5. Remove the brackets from the wiper motor crank arm.
6. Remove the three bolts and the wiper motor from the vehicle.
INSTALLATION PROCEDURE
1. Install the wiper motor on the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the three bolts.
Tighten
Tighten the three bolts to 7 N.m (62 lb in).
3. Install the drive link brackets to the wiper motor crank arm with the right side linkage closest to the wiper motor.
Tighten
Tighten the link nuts to 5 N.m (44 lb in).
4. Connect the electrical connector to the wiper motor.
5. Install the air inlet grille panel.
6. Install the wiper arms.
