K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
Front Door Interior Handle: Service and Repair
Door Handle Replacement
Removal Procedure
Tools Required
J 34940 Rivet Gun
1. Remove the trim panel.
2. Remove the water deflector.
3. Remove the inside door handle assembly by completing the following steps:
-
Drill out the rivet head using a 5-mm (0.2-in) drill bit.
-
Slide forward the door handle.
4. Disconnect the control rods from the handle and the lock lever.
Installation Procedure
1. Connect the control rods to the handle and the lock lever.
2. Install the inside door handle by completing the following steps:
-
Insert the handle assembly into the slot.
-
Slide the assembly to the rear.
-
Using the J 34940, install the handle rivet.
3. Install the water deflector.
4. Install the trim panel.
