K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
3. Install the exhaust manifold heat shield to the exhaust manifold.
^
Tighten the bolts and stud/nuts to 50 Nm (37 ft. lbs.).
3. Install the exhaust shields to the front corner of the exhaust manifold.
3.1.
Tighten the bolts to 10 Nm (8 ft. lbs.)
3.2.
Tighten the nuts to 42 Nm (31 ft. lbs.)
4. Install the exhaust crossover pipe from the left exhaust manifold to the turbocharger. Refer to Exhaust Crossover Pipe Replacement (Diesel) in
Exhaust System.
5. Remove the safety stands and lower the vehicle.
6. Install the glow plugs to the cylinder head. Refer to Glow Plug Replacement - Left Side in Powertrain Managements.
7. Install the left front inner wheel housing.
8. Install the left front wheel on the vehicle.
9. Connect the battery negative cables to the batteries. Refer to Battery Cable in Powertrain Management.
