K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
Turn Signal Lamp: Service and Repair
Park/Turn Signal Lamp Replacement (Base with Sealed Beam)
REMOVAL PROCEDURE
1. Make sure the headlamp switch is in the OFF position.
2. Remove the screws.
3. Remove the park/turn signal lamp assembly.
4. Disconnect the electrical connector.
5. Remove the bulbs from the assembly.
INSTALLATION PROCEDURE
1. Install the bulbs to the park/turn signal lamp assembly.
2. Insert the tab into the grille.
3. Install the lamp assembly.
4. Connect the park/turn signal lamp connector.
5. Install the screws.
