K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
5. Position the tool J 41364-A onto the park/neutral position switch. Ensure that the two slots on the switch where the manual shaft is inserted are
lined up with the lower two tabs on the tool.
Notice: Refer to Fastener Notice in Service Precautions.
6. Rotate the tool until the upper locator pin on the tool is lined up with the slot on the top of the switch.
-
Tighten the bolts securing the switch to 28 Nm (21 ft. lbs.).
7. Remove J 41 364-A from the switch.
8. Install the wiring harness connector to the switch.
9. Install the transmission control lever to the manual shaft with the nut.
-
Tighten the control lever nut to 28 Nm (21 ft. lbs.).
10. Lower the vehicle.
11. Connect the negative battery cable.
12. Check the switch for proper operation. The engine must start in the P (Park) or N (Neutral) positions only.
