R 2500 P/U 2WD V8-454 7.4L (1988)
-
Hold the pilot bolt and turn the nut clockwise.
-
On models equipped with a remote power steering pump reservoir fill the pump housing with as much fluid as possible before mounting.
3. Pump assembly and attaching parts loosely to the engine.
4. Power steering hoses to the pump. Hoses installed out of position may be subjected to chafing or other abuses during sharp turns.
IMPORTANT: Do not start the engine with any power steering hoses disconnected. After connecting the power steering hoses make sure there is
clearance between the hoses and the drive belt, sheet metal or any other components where hose chafing or interference could result.
-
Fill the reservoir Bleed the pump by turning the pulley backwards (counterclockwise as viewed from the front) until the air bubbles cease to
appear.
TIGHTEN
-
All fasteners. Refer to the appropriate figure and the "Specifications".
5. Pump belt over the pulley.
ADJUST
-
Belt tension.
-
Fill and bleed the system.
