R 2500 P/U 2WD V8-454 7.4L (1988)
Fig. 8 Lower bearing adjustment
Manual Transmission w/Column Shift
1.
Put transmission in Neutral position, then disconnect transmission rods.
2.
Test for rotational drag by turning shift lever through 2--3 shift arc. Drag measured must not be more than two pounds.
3.
Loosen three clamping screws, then proceed as follows:
a.
Increase clearance by sliding clamping screws in direction of arrow ``B'' until first reverse lever is free of drag, Fig. 8.
b.
Decrease clearance by sliding clamping screws in direction of arrow ``A'' until a slight drag is felt at first reverse shift lever, Fig. 8.
4.
Install a .005 inch thick shim between space and either shift levers.
5.
Slide clamping screws in direction of arrow ``B'' until system is loose. Slide screws in opposite direction until a drag is felt at first reverse shift
lever.
6.
Tighten clamping screws, then remove shim.
7.
Install transmission rods.