gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Tune-up and Engine Performance Checks > < General Information|Page 1738
Page 1
background image

Timing Cover: Service and Repair

REMOVE OR DISCONNECT

1.  Water pump. Refer to Water Pump / Service and Repair.  See: Water Pump/Service and Repair
2.  Power steering pump bracket (if equipped).
3.  Harmonic Balancer. Refer to Harmonic Balancer / Service and Repair.  See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft

Pulley/Service and Repair

4.  Lower radiator hose from the front cover. Drain the cooling system.
5.  Remaining front cover bolts.
6.  Front cover.
7.  Gasket.

CLEAN

^ Old gasket from the front cover and block.

INSTALL OR CONNECT

1.  New gasket.

^  Make sure sealing surfaces are clean.
^  Take care not to damage sealing surfaces.
^  Lightly coat both sides of the gasket with anaerobic sealer.

2.  Front cover.
3.  Water pump. Refer to Water Pump / Service and Repair.  See: Water Pump/Service and Repair
4.  Bolts and stud.

Tighten
^  Bolts and stud to specification. Refer to Specifications / Mechanical / Engine Tightening Specifications.

5.  Lower radiator hose to the front cover.
6.  Harmonic Balancer. Refer to Harmonic Balancer / Service and Repair.  See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft

Pulley/Service and Repair

7.  Power steering pump mounting bracket (if equipped).
8.  Accessory drive belt.
9.  Negative battery cable.

10.  Proper quantity and grade of coolant.

Tune-up and Engine Performance Checks > < General Information|Page 1738