S15/T15 2WD Jimmy V6-173 2.8L (1988)
FIGURE 3
6.
Route the vacuum line under the dash to the glove box area (see Figure 3).
7.
Open the glove box and remove the rear panel to gain access to the rear of the dash. It will also be necessary to remove the insulator assembly
under the dash for full access. Locate the Max A/C line going to the plenum valve and the air recirculation door valve. The line is black plastic
with an orange stripe.
8.
Cut the line and insert Tee coupling. See view 'A' in Figure 3. Use 3/32 rubber vacuum line for the couplings. Install the added vacuum line to the
bottom leg of the Tee. Accumulator Insulation Installation:
1.
Install the upper and lower insulators (3) and
(4)
on the A/C accumulator assembly (see Figure 4).
