S15/T15 2WD Jimmy V6-173 2.8L (1988)
^
Place J 25031 down into the rotor until the puller legs engage the recessed edge of the rotor hub.
^
Tighten the puller screw against the puller guide and remove the clutch rotor and bearing.
Important
^
If the pulley rim mounting screws (10) and washers (9) were removed, only the clutch rotor and bearing assembly will be removed for
replacement. The clutch coil and housing assembly is pressed into the compressor and will not be removed unless the pulley rim mounting
screws are left in place and the pulley rim pulls the coil and housing assembly off with the clutch rotor and pulley rim assembly.
Removing The Clutch Rotor Bearing
4. Bearing (6) from the clutch rotor (5) with J 8092 and J 9398-A.
^
Place the clutch assembly face on wood blocks to remove the bearing.
Important
^
It is not necessary to remove the staking at the rear of the rotor hub to remove the bearing. However, file away the old staked metal to provide
a dearance for the new bearing.
Install or Connect
Tools Required:
J 6083 External Snap Ring Pliers
J 8092 Drive Handle
J 9481-A Pulley Bearing and Pulley Installer
Installing The Clutch Rotor Bearing
1. Bearing (6) to the rotor hub with J 8092 and J 9481-A.
^
Place the rotor and hub assembly face down on a clean, flat surface.
^
Align the bearing with the hub bore.
^
Drive the bearing with J 8092 and J 9481-A.
