S15/T15 2WD Jimmy V6-262 4.3L (1991)
Removing The Shaft Nut
-
Clamp J 33026 in a vise and attach the compressor to the holding fixture with thumb screws.
1. Shaft nut (1) using J 33022.
-
Hold the clutch plate and hub assembly (2) steady using J 33027-A.
2. Clutch plate and hub assembly (2).
-
Thread J 33013-B into the clutch plate and hub assembly (2).
Removing The Clutch Plate & Hub Assembly
-
Hold the body of J 33013-B with a wrench and tighten the center screw into the remover body.
3. Shaft key (21).
-
Retain shaft key (21) if usable.
Inspect
-
All parts and replace as necessary.
Install or Connect
Tools Required:
J 33013-B Hub and Drive Plate Remover and Installer
J 33022 6-Point 13 mm Socket