S15/T15 2WD Jimmy V6-262 4.3L (1991)
-
Install J 9625-A onto the rear head of the compressor and connect gage charging lines, or pressurize suction side (low pressure side) of
compressor on vehicle with Refrigerant-12 vapor to equalize pressure to the drum pressure. Temporarily install the shaft nut and with the
compressor in a horizontal position and using a wrench, rotate the compressor shaft in normal direction of rotation several times by hand. Leak
test the seal and correct any leak found. Remove, discard and later replace with a new shaft nut.
7. Excess oil, resulting from installing the new seal parts, from the shaft and inside the compressor neck.
8. Clutch plate and hub assembly.
