S15/T15 2WD Jimmy V6-262 4.3L (1991)
Wheel Bearing: Adjustments
Two Wheel Drive - 2WD
FRONT WHEEL BEARINGS ADJUSTMENT
4 X 2 MODELS
1.
Raise and support front of vehicle.
2.
Remove hub dust cover, then the cotter pin.
3.
While rotating wheel assembly in forward direction, torque spindle nut to specification to fully seat the bearings.
4.
Loosen nut to the ``just loose'' position, then tighten the spindle nut finger tight.
5.
If either spindle hole does not line up with a spindle nut slot, back off spindle nut not more than 1/2 nut flat.
6.
Install new cotter pin, then measure hub endplay. Endplay should be .001-.005 inches when properly adjusted.
7.
Install hub dust cover and lower vehicle.
4 X 4 MODELS
These vehicles use sealed front wheel bearings which require no lubrication or adjustment.
