S15/T15 2WD Jimmy V6-262 4.3L (1991)
Steering Column: Service and Repair
Ignition Switch
The ignition switch is mounted on top of the column jacket near the front of the dash. For anti-theft reasons, the switch is located inside the channel
section of the brake pedal support.
The switch is actuated by a rod and rack assembly. A portion of the rack is toothed and engages a gear on the end of the lock cylinder. This enables
the rod and rack to be moved axially (with respect to the column) to actuate the switch when the lock cylinder is rotated.
Remove or Disconnect
^
Lower the steering column, please refer to Steering and Suspension /Steering/Steering Column/Service and Repair/ See: It is not necessary to
remove the steering wheel.
Important
^
Properly support the steering column if it is not removed from the vehicle.
^
Put the ignition switch in the "Lock" position.
^
If the lock cylinder was removed, the actuating rod to the switch should be pulled up until there is a definite stop, then moved down one
detent, which is the "Lock" position.
1. Two ignition switch screws.
2. Ignition switch assembly.
Install or Connect
^
Put the ignition switch in the "Lock" position.
1. Activating rod into the ignition switch.
2. Ignition switch and screws to the column.
3. Steering column assembly, please refer to Steering and Suspension /Steering/Steering Column/Service and Repair/ See:
