S15/T15 2WD Jimmy V6-262 4.3L (1991)
Figure 11 - Snap Ring and Spider Removal
5. To remove the spider assembly (also required for seal replacement), spread the spacer ring with tool J8059 or equivalent and slide the ring and spider
assembly up on the shaft (Figure 11). This will provide access to the shaft retaining ring in the groove at the end of the shaft. Remove the retaining
ring, spider assembly, spacer ring, and seal.
Figure 12 - Small Retaining Clamp Installation
6. Clean the shaft. If rust is present in the seal mounting area (grooves), wire brush this area (Figure 12).
7. Slide the new small seal clamp and seal onto the shaft to the proper position.
8. Secure the clamp with tool J35910, breaker bar and and torque wrench. Torque small clamp to 136 N-m (100 lbs.ft.). Check clamp ear gap
dimension (Figure 12).
