S15/T15 2WD Jimmy V6-262 4.3L VIN W CPI (1993)
Rotor & Bearing Assembly
It is not necessary to remove the staking at the rear of the rotor hub to remove the bearing. However, it will be necessary to file away the old stake
metal for proper clearance for the new bearing to be installed into the rotor bore, or the bearing may be damaged.
Install or Connect
1. Place the Rotor and Hub assembly face down on a clean, flat and firm surface.
Installing Clutch Rotor Bearing
2. Align the new bearing squarely with the hub bore and using Pulley and Bearing Installer J 9481-A with Universal Handle J 29886, drive the
bearing fully into the hub. The Installer will apply force to the outer race of the bearing if used.
3. Using a center punch with a 45° angle point. stake 1.1-1.4mm (0.045-055" deep) the bearing in three places 120° apart, but do not stake too
deeply to avoid distorting the outer race of the bearing.
4. Replace rotor and bearing assembly.
On-Vehicle
A.
Position the Rotor and Bearing assembly on the front head.
