gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Transfer Case - Noise in 2 Wheel Drive|Page 3246 > < Drive Axle (Front) - Will Not Disengage|Page 3237
Page 1
background image

Drive Sprocket: Customer Interest
Transfer Case - Noise in 2 Wheel Drive

Number:

86-249

Section:

7D

Date:

September, 1987

SUBJECT:

207 TRANSFER CASE NOISE IN WHEEL DRIVE

MODELS:

1985-86 T TRUCKS

FIGURE NO. 1

Some 1985 and 1986 T trucks may experience a high pitched (bearing type) whining noise while operating in 2 wheel drive. These vehicles can be
checked for this condition by applying firm pressure to the transfer case shift lever and pulling the lever in the direction of 4 High. If this eliminates the
whining noise, the condition can be repaired by replacing the two sprocket bearings (See Figure No. 1 - Item 31). This condition is caused by the needle
bearings which are inside the sprocket bearing having skewed (turn slightly sideways), which causes them to slide instead of roll. The above situation
was repaired by using a caged bearing on transfer cases dated 4-1-86 and later, which can be identified by the serial number tag that is located on the
rearward side
of the transfer case. The serial number is the Date Code. Example - Serial Number 4-1-86 (April 1, 1986).
SERVICE PARTS

Transfer Case - Noise in 2 Wheel Drive|Page 3246 > < Drive Axle (Front) - Will Not Disengage|Page 3237