S15/T15 2WD P/U L4-137 2.2L DSL VIN S (1984)
Fig. 2 Removing Accumulator
Fig. 6 Removing accumulator valves
Fig. 7 Accumulator valves
10.
Install accumulator retaining cap tool No. J-26889 over master cylinder stud and install nut as shown in Fig. 5.
11.
Depress accumulator, using a suitable C-clamp, Fig. 5, then insert a punch into hole in housing and remove retaining ring with a suitable
screwdriver.
12.
Slowly back off C-clamp until tension on the accumulator is released, then remove accumulator and O-ring.
13.
If accumulator valve is to be removed, fabricate tool from .040 inch diameter wire as shown in Fig. 6. Remove dump valve by catching tool under
pin guide near center of valve, then remove check valve assembly and seat, Fig. 7.
14.
Remove hose fitting O-ring, if necessary.
15.
Remove spool plug retaining ring, then the spool plug and O-ring.
