S15/T15 2WD P/U L4-137 2.2L DSL VIN S (1984)
Spacer Plate
3.
On a 1984 or 1985 THM 200C transmission built prior to September 25, 1985 (Julian Date 268), remove the spacer plate and drill the 2nd and 3rd
clutch exhaust orifice out to 3.57 mm (9/64") (Figure 2). Using a 6.3 mm drill bit, hand chamfer both sides of the hole slightly, to remove burrs
and rough edges.
Pressed On Rear Internal Gear
4.
On a THM 200C transmission built prior to January 10, 1986, Julian Date 016, replace the rear internal gear and output shaft with the new pressed
on assembly, (Figure 3) Part Number 8633910.
5.
Upon reassembly of the transmission, reduce the transmission output shaft rear end play to .10 mm - .38 mm (.004 - .015 inches) by using a thicker
selective washer, if required. Do not let rear end play get lower than .004 inches. Transmission damage may result.
