S15/T15 2WD P/U V6-262 4.3L (1988)
1. Mounting to crossmember nut(s) and washer(s).
2. Mounting to transmission bolts and washers.
-Raise the rear of the engine only enough to permit removal of the mounting.
3. Mounting.
Install or Connect
1. Mounting.
-Lower the rear of the engine.
2. Mounting to transmission bolts and washers.
NOTICE: When fasteners are removed, always reinstall them at the same location from which they were removed. If a fastener needs to be replaced,
use the correct part number fastener for that application. If the correct part number fastener is not available, a fastener of equal size and strength (or
stronger) may be used. Fasteners that are not reused and those requiring thread locking compound will be called out. The correct torque value must be
used when installing fasteners that require it. If the above condition are not followed, parts or system damage could result.
3. Mounting to crossmember nut(s) and washer(s).
-Tighten fasteners to specifications as shown in the image.
