S15/T15 2WD P/U V6-262 4.3L (1988)
Removing The Clutch Plate & Hub Assembly
^
Hold the body of J 33013-B with a wrench and tighten the center screw into the remover body.
3. Shaft key (21).
^
Retain shaft key (21) if usable.
Inspect
^
All parts and replace as necessary.
Install or Connect
Tools Required:
J 33013-B Hub and Drive Plate Remover and Installer
J 33022 6-Point 13 mm Socket
J 33027 Clutch Hub Holding Tool
J 34992 Compressor Holding Fixture
1. Shaft key (21).
Removing The Clutch Plate & Hub And Shaft Key
^
Allow the shaft key (21) to extend 3.2 mm (11a-inch) out of the bottom of the hub keyway.
^
The shaft key (21) is curved slightly to give an interference fit in the groove.
Important
^
Do not drive or pound on the clutch hub or the shaft (38). Internal damage to the compressor may result.
