S15/T15 2WD P/U V6-262 4.3L (1988)
J 33026 Compressor Holding Fixture
J 33027 Clutch Hub Holding Tool
J 33022 6-Point 13 mm Socket
J 33013-B Hub and Drive Plate Remover and Installer
1. Shaft key (1).
Positioning The Shaft Key, Clutch Plate & Hub Assembly
^
Allow the shaft key (21) to extend 3.2 mm (118-inch) out of the bottom of the hub keyway.
^
The shaft key is curved slightly to give an interference fit in the groove.
Important
^
Do not drive or pound on the clutch hub or the shaft (20). Internal damage to the compressor may result.
Installing The Clutch Plate & Hub Assembly
2. Clutch plate and hub assembly (2).
^
Make sure the contact surfaces of the clutch plate (2) and the pulley (5) are clean.
^
Remove the forcing screw tip from J 33013-B and reverse the body direction on the center screw.
^
Install J 33013-B with bearing.
^
Back off J 33013-B body enough to allow the center screw to be threaded against the end of the compressor shaft.
^
Hold the center screw with a wrench and tighten the hex portion of J 33013-B body while pressing the hub onto the shaft. After tightening the
