S15/T15 2WD P/U V6-262 4.3L VIN W CPI (1993)
Removing Poly-Groove Clutch Coil
Removing Poly-Groove Clutch Coil (Optional Method)
3. Install the rotor and bearing assembly retaining ring and reassemble the Clutch Plate and Hub assembly as described in "Compressor Clutch Plate
and Hub Assembly" Replacement procedure. Check to see that the clutch plate to clutch rotor air gap is 0.5-7.6mm (0.020-0.030").
-
Rotate the Pulley Rim and Rotor to be sure the Pulley Rim is rotating "in-line" and adjust or replace as required.
4. Tighten the pulley rim mounting screws to 11 N.m (100 in.lbs.) torque and lock the screw heads in place by bending screw head washer, similar to
original crimp and lock bends on washers.
