S15/T15 2WD P/U V6-262 4.3L VIN W CPI (1993)
Throttle Position Sensor: Description and Operation
TP Sensor
Throttle Position Sensor (TPS)
PURPOSE
The Throttle Position Sensor (TPS) is a non-adjustable potentiometer that senses throttle angle and relays the information to the control module. This
input to the control module is used to control the fuel system and most of the control module outputs.
CONSTRUCTION
The TPS has internally three circuits. One to ground, the other from the control module as a 5.0 volt reference source and a third circuit is used by the
control module to measure the output voltage . As the throttle angle changes (pressing down on accelerator pedal) the TPS voltage output varies from
about .5 volt at idle to about 4.9 volts at wide open throttle (WOT).
OPERATION
As the throttle valve rotates in response to movement of the accelerator pedal, the throttle shaft transfers this rotation movement to the TP sensor. A
potentiometer (variable resistor) within the Throttle Position (TP) sensor assembly changes its resistance in proportion to throttle movement.
If the TP sensor senses a Wide Open Throttle (WOT) a voltage signal indicating this condition is sent to the control module. The control module then
increases the injector base pulse width, permitting increased fuel flow.
LOCATION
The non-adjustable Throttle Position (TP) sensor, is mounted on the side of the throttle body opposite the throttle lever assembly.
