S15/T15 2WD P/U V6-262 4.3L VIN Z (1992)
Important:
If the original pre-load torque value was < (less than) 3 lb.in., then reset torque specifications to 3-5 lb.in.
Important:
If the pinion seal and collapsible spacer are replaced, then refer to the appropriate Unit Repair Manual of pinion re-load specifications.
4.
Install the "Dual Double Cardon" two piece propeller shaft and attaching bolts and nuts.
5.
Apply a coating of GM P/N 12345382 Thread Lock or Loctite(R) # 242 or equivalent to the mounting bolt threads to flange.
Tighten
Tighten bolts to 50 Nm (37 lb.ft.).
6.
Install the rear axle brake drum and wheel assemblies.
7.
Add lubricant to the rear axle as necessary.
PARTS INFORMATION
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicles repaired under warranty.
