S15/T15 4WD Jimmy L4-121 2.0L VIN Y 2-bbl (1983)
applicable 1982 vehicles.
FIGURE 2A - INSTALLATION OF TRANSMISSION DAMPER ASM.
1983 Vehicles
The original transmission mount and associated parts must be replaced when installing the damper on all applicable 1983 vehicles
produced before the damper was available. Figure 2-A shows those parts which are to be discarded. Install the damper assembly using the
parts listed below. The installation
is shown in Figure 2-B. The transmission support member is already slotted to accommodate the dual captive stud mounting feature of the new mount
assembly.
Parts for 1983 Vehicles
14027910
Mount Assembly
11504597
Retainer Bolts (Standard Part)
3790768
Washers (Standard Part)
Finalize each installation by torquing the retainer bolts to 54-65 N-m (40-43 ft.lbs.) and the torque-prevailing nuts to 28-38 N-m (21-28 ft.lbs.).
Prior to reuse, clean and inspect the torque-prevailing nuts for damage. Replace nut with P/N 11501033 (standard part) if necessary.