S15/T15 4WD Jimmy L4-151 2.5L (1985)
Four Wheel Drive Selector Switch: Service and Repair
Fig. 2 Transfer case shift linkage
Fig. 4 Selector switch installation
1.
Disconnect battery ground cable.
2.
Remove console, then disconnect console wiring harness.
3.
Remove shifter boot retaining screws and slide boot up shift lever.
4.
Remove switch attaching screw, then the switch and harness, Fig. 2.
5.
Position new switch on mounting bracket and install attaching screw.Ensure shift lever assembly pawl is on the switch contact carrier.
6.
Route wiring as shown in Fig. 4.
7.
Place shifter boot in proper position, then install retaining screws.
8.
Connect console wiring harness, then install console.
9.
Connect battery ground cable.
