S15/T15 4WD Jimmy V6-262 4.3L VIN W CPI (1993)
Reinstall the bumper by starting its installation by pushing the rearward edge in position first and follow with the front edge while working across
the cross rail. Check to ensure the bumper edges are flush (flat) against the cross rail.
3.
Install cross bar into mounted rail assembly. Using ONLY hand tools, install the fasteners and tighten to 2.2 to 3.4 N-m (1.6 - 2.5 lbs.ft.).
4.
Install the remaining rail assembly and rail supports. HAND START the four (4) mounting fasteners and tighten ALL eight rail support fasteners
to 2.2 to 3.4 N-m (1.6 - 2.5 lbs.ft.). USE ONLY HAND TOOLS TO INSTALL FASTENERS.
5.
Remove tape and "front" stickers from rails and cross bar assemblies.
