S15/T15 4WD Jimmy V6-262 4.3L VIN W CPI (1993)
Balance Shaft Bearing: Service and Repair
BALANCE SHAFT REMOVAL
TOOLS REQUIRED:
J 38834 Balance Shaft Bearing Service Kit J 26941 Bearing Remover
Installing Balance Shaft And Components
REMOVE OR DISCONNECT
1. Bolt (49).
2. Driven gear (42).
3. Retainer bolts (48).
4. Retainer (43).
5. Balance shaft (47) using a soft faced hammer.
6. Balance shaft rear bearing (45) using J 38834 and J 26941.
IMPORTANT
^
The balance shaft with front bearing are serviced as an assembly.
^
Use only the correct tools for bearing and shaft installation.
^
inspect the balance shaft driven gear and the drive gear for nicks and burrs.