S15/T15 4WD Jimmy V6-262 4.3L VIN W CPI (1993)
Removing And Installing Seal And O-Ring (One Piece Seal)
Fully engage the knurled tangs of Seal Remover-Installer J 23128-A into the recessed portion of the Seal by turning the handle clockwise. Remove
the Seal from the compressor with a rotary-pulling motion. Discard the Seal. The handle must be hand-tightened securely. Do not use a wrench or
plier.
7. Remove and discard the seal seat O-ring from the compressor, neck using O-Ring Remover J 955301.
8. Recheck the shaft and inside of the compressor neck and O-ring groove for dirt or foreign material and be sure these areas are perfectly clean
before installing new parts.