S15/T15 4WD Jimmy V6-262 4.3L VIN W CPI (1993)
Steering Gear: Service and Repair
Saginaw Integral Power Steering Gear
Removal/Installation
1.
On models equipped with power steering, disconnect pressure and return hoses from steering gear housing, then plug hose ends and gear
housing ports to prevent entry of dirt.
2.
On all models, disconnect battery ground cable and remove coupling shield if so equipped.
3.
Remove retaining nuts, lock washers and bolts at steering coupling to steering shaft flange.
4.
Remove pitman arm nut and washer from pitman shaft and mark relation of arm position to shaft, then remove pitman arm using a puller.
5.
On turbocharged models, raise and support vehicle.
6.
Remove charge air cooler radiator.
7.
Lower vehicle, then remove intermediate shaft assembly at steering gear.
8.
Remove attaching bolt and nut to pot joint coupling. Ensure alignment marks line up.
9.
On all models, remove screws securing steering gear to frame and remove gear from vehicle.
10.
Reverse procedure to install.
Disassembly
If broken components or foreign materials are found during disassembly of the gear, the hydraulic system should be inspected, cleaned and
flushed before service is complete.
The ball nut and control rings are not generally replaced unless cut or damaged. If replacing, inspect all mating parts for burrs, cracks, scratches or
damage. Replace or repair as needed.
Fig. 1 Exploded view of power steering gear
