S15/T15 4WD P/U L4-119 1.9L (1985)
3.
Mark old rubber cap to distinguish from new part (the new part is same as the old part, except for an increased width which is not detectable).
4.
Remove old rubber cap.
5.
Lube the new cross rail cap with mild soap and water or equivalent.
6.
Slide in new rubber cap, wide side forward. (Cross rail does not need to be removed as the new part can be worked into place by hand.)
7.
Test vehicle for howl condition.
In most cases only the front cross rail cap will be needed to eliminate the howl condition. However, if appropriate, this procedure may be applied to the
rear cross rail cap as well.
NOTE:
Install cross rail and cross rail cap with wide side forward as shown in Figure 1. Do not cut cross rail cap to fit, work into cross rail until all
slack has been removed.
SERVICE PARTS INFORMATION
Part Number
Description
Quantity
15659287
Rubber cross
1 per rail
rail cap
(as needed)
Parts are currently available through GMSPO.
WARRANTY INFORMATION For vehicles repaired under warranty use:
Labor Operation:
R2380
Labor Time:
0.4 hr.