S15/T15 4WD P/U V6-262 4.3L VIN W CPI (1992)
14. Idler arm.
15. Front differential through bolts.
16. Front propeller shaft (roll differential forward).
17. Starter bolts.
18. Starter motor and lay aside.
19. Oil pan bolts, nuts, and reinforcements.
20. Oil pan and gasket.
Clean
-
Sealing surfaces on the engine and oil pan.
Inspect
-
Oil pan gasket. Replace if necessary.
Install or Connect
-
Apply sealant (GM part number 1052080 or equivalent) to the front cover to block joint and to the crankshaft rear seal to block joint. Apply the
sealant for about 25 mm (1 inch) in both directions from each of the four corners.
1. Oil pan gasket to the oil pan.
2. Oil pan to the engine.
3. Oil pan bolts, nuts and reinforcements.
Tighten
-
Oil pan bolts to 11 N.m (100 in. lbs.).
-
Oil pan nuts at corners to 23 N.m (17 ft. lbs.).
4. Starter motor.
5. Starter motor bolts.
