S15/T15 4WD P/U V6-262 4.3L VIN W CPI (1992)
Intermediate Shaft: Service and Repair
BALANCE SHAFT REPLACEMENT
Remove
Tools Required:
J 23523-E Torsional Damper Puller and Installer.
J 26941 Needle Bearing Remover
J 38834 Balance Shaft Bearing Service Kit.
1. Negative battery cable.
2. Air cleaner and air intake duct.
-
Drain the cooling system.
3. Discharge A/C system.
4. Upper radiator shroud.
5. Oil cooler lines at the radiator.
6. Transmission cooler lines at the radiator.
7. Upper radiator hose.
8. Heater hose and overflow hose from radiator.
9. Lower radiator hose.
10. Radiator.
11. A/C condenser.
12. Fan assembly.
13. Multiple ribbed belt.
14. Pencil brace at coolant pump.
15. Coolant pump.
16. Torsional damper. Use J23523-E.
17. Flywheel inspection cover.
-
Drain engine oil.
-
Loosen the oil pan. Remove the two nuts and the first two bolts on either side at the front of the oil pan, all other oil pan fasteners must be very
loose.
18. Front cover bolts and front cover.
Important
-
Use care when removing the front cover from the front of the oil pan gasket.
19. Crankshaft front oil seal from the front cover.
20. Timing chain bolts.
