S15/T15 4WD P/U V6-262 4.3L VIN W CPI (1992)
Compressor Clutch Coil: Service and Repair
With HR6-HE Compressor
Remove or Disconnect
1. Perform Steps 1 through 4 of "Clutch Rotor and/or Bearings" removal procedure. Mark clutch coil terminal location on compressor front
head.
Clutch Coil Assembly Removal
2. Install J 33023-A puller pilot on front head of compressor. Also install J 8433-1 puller crossbar with J 33025 puller legs.
3. Tighten J 8433-3 forcing screw against the puller pilot to remove the clutch coil.
Install or Connect
1. Place the clutch coil assembly on the front head with the terminals positioned at the "marked" location.
2. Place the J 33024 clutch coil installer over the internal opening of the clutch coil housing and align installer with the compressor front head.
