S15/T15 4WD P/U V6-262 4.3L VIN W CPI (1992)
12.
Disconnect electrical terminals from pump;
13.
Remove clamps from rubber coupler.
NOTE:
MARK POSITION OF STRAINER ON PUMP; remove strainer by rotating in one direction while pulling off and discard.
14.
Pull the fuel pump up into the attaching hose while pulling outward from the bottom support.
Do not damage rubber isolator.
15.
Install fuel pump assembly into the attaching hose.
NOTE:
The fuel pump cannot be run dry because bearing damage can result in as little as 15 seconds. Also, care must be taken not to fold over or twist the
strainer, when installing the sending unit as this will restrict fuel flow.
Use the new strainer and align to original position.
16.
Seat rubber isolator and pump securely in mounting bracket.
Tighten both clamps securely.
17.
Install sending unit and fuel pump assembly into the fuel tank.
-
Use the new O-ring seal.
18.
Reinstall fuel tank as per specifications in Figure 4-47 in
X-9129 S/T Truck Service Manual, page 4-31, and reconnect hoses and electrical connectors.
19.
Connect propshaft, torque to 29 N-m (15 lbs.ft.).
20.
Lower vehicle.
21.
Connect negative battery cable.
22.
Check old fuel for contamination before refilling fuel tank.
23.
Start vehicle and inspect all connections for leaks.
24.
Install "Campaign Identification Label".
Part and Warranty Information
PARTS INFORMATION
Parts are to be obtained from General Motors Service Parts Operation (GMSPO). To ensure that these parts will be obtained as soon as possible, they
should be ordered from GMSPO on a C.I.O. order with no special instruction code but order under an advise code (2).
QUANTITY
PART NUMBER
DESCRIPTION
PER VEHICLE
25027768
Fuel Meter Kit
1
WARRANTY INFORMATION
Dealers should submit an accurately filled out Warranty Repair Order on each vehicle completed under this campaign.
LABOR
OPERATION
*TIME
TROUBLE
NUMBER
DESCRIPTION
ALLOWANCE
CODE
V6960
R & R Fuel (In Tank)
1.8 HR
96
Pump