S15/T15 4WD P/U V6-262 4.3L VIN W CPI (1992)
10.
Install flow control spring, control valve, O-ring seal and O-ring.
11.
Install reservoir or return tube, then clips if equipped.
System Bleeding
1.
Fill pump fluid reservoir to proper level and let fluid settle for at least two minutes.
2.
Start and run engine for a few seconds. Do not turn steering wheel.
3.
Turn engine Off. Check fluid level, add fluid if necessary.
4.
Repeat above procedure until fluid level remains constant after running engine.
5.
Raise front end of vehicle so wheels are off ground.
6.
Start engine. Slowly turn steering wheel in both directions, lightly contacting wheel stops.
7.
Add power steering fluid, if necessary.
8.
Lower vehicle and turn steering wheel slowly from lock to lock.
9.
Stop engine. Check fluid level and refill as required.
10.
If fluid is extremely foamy, allow vehicle to stand a few minutes and repeat above procedure.
