S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
Carpet: Customer Interest
Carpet - Loose on Side Wall Trim Pads
GMC NUMBER:
90-10-21
GROUP:
10 Body Section
DATE:
December, 1989
CORPORATE
NUMBER:
931053
SUBJECT:
LOOSE CARPET ON SIDE WALL TRIM PADS (REPAIR PROCEDURE)
MODELS:
1980-90 ALL TRUCKS
Carpet inserts attached to side wall, door, quarter and tailgate trim panels which have become loose may be reattached with 3M General Trim Adhesive #
08080. Use the following procedure:
1.
Remove trim panel when necessary and place on clean work surface. Mask off trim panel to prevent glue over spray.
2.
Sand area of trim panel where carpet is to be reglued using a coarse grit sandpaper. Polypropylene Panels should have a rough surface for best
adhesion. Remove all sanding debris.
3.
Spray 3M General Trim Adhesive # 08080 on sanded surface and back side of carpet following manufacturer's instruction.
4.
When both sprayed surfaces become tacky to the touch, press carpet in place, smooth out any irregularities.
5.
Remove masking materials and reinstall panel.
"We believe this source and their product to be reliable. There may be additional manufacturers of such products. General Motors does not endorse,
indicate any preference for, or assume any responsibility for the products or equipment from these firms or for any such items which may be available
from other sources." For vehicles repaired under warranty use applicable trim panel R & R Labor Operation and S. T. (Straight Time) in the other hours
column for regluing carpet panels.
