S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
COWL VENT ASSEMBLY
7.
Measure 1-1/4" down from the bottom of the windshield and make a horizontal mark on the windshield frame inboard of the cowl screen lock tab
(Figure No. 1).
8.
Measure 7/8" inboard from the cowl screen lock tab and make a vertical mark through the line made in the previous step.
9.
Center punch the windshield frame at the point the lines intersect. Use a one inch hole saw to cut a hole in the windshield frame (cut through only
the first layer of sheet metal) and remove the circular piece of metal that remains from cutting the hole. DO NOT CUT THE SECOND LAYER
PANEL.
10.
Drive the door frame (the second layer of sheet metal) down with a punch approximately 1/4" all the way around the hole.
