S15/T15 Jimmy 2WD V6-262 4.3L VIN W CPI (1995)
Crankshaft Position Sensor: All Technical Service Bulletins
Crank Position Sensor - Installation
File In Section: 6E - Engine Fuel & Emission
Bulletin No.: 47-65-18
Date: September, 1994
Subject:
Crank Position Sensor Installation
Models:
1995 Chevrolet and GMC Truck S/T Models with 4.3L Engine
(VIN W - RPO L35)
The crank position sensor must be fully seated and held prior to tightening the hold down bracket bolt (see Figure 1). Torque the hold down bracket bolt
to 8 - 9 N-m (5.9 - 6.6 lb.ft.). Use hand tools only - do NOT exceed the torque specification.
A sensor which is cocked and/or loose in the front cover bore may cause the holding bracket to bend and/or lead to setting the following DTCs:
Note:
Misfire detection may only occur above 2400 engine RPM in this instance.
It these codes are detected, check the crank position sensor for proper seating.
