S15/T15 Jimmy 2WD V6-262 4.3L VIN Z (1994)
Rotor And Bearing Assembly
B. With Rotor & Bearing Installer J 26271-A (without driver handle) in position and Rotor and Bearing assembly aligned with the Front Head as
shown in the illustration, drive the assembly part way onto the head.
C. Plug clutch coil connector onto Clutch Coil.
D. Position the Clutch Coil so the three (3) locating tabs will align with the holes in the head and continue to drive the Rotor and Bearing
assembly onto the front head.
E. Install the retainer ring.
F. Reassemble the Clutch Plate and Hub with the shaft key onto the shaft with Installer J 9401-B until 0.5-7.6mm (0.020-0.030") air gap is
obtained.
G. Install shaft lock nut. Torque to 14 N.m (10 lb.ft.).
On-Bench
Installing Rotor & Bearing Assembly
