S15/T15 Jimmy 2WD V6-262 4.3L VIN Z (1994)
Compressor Clutch Hub: Service and Repair
With SD-7H15 Compressor
Disassemble
Remove or Disconnect
Tools Required:
J 6435 External Snap Ring Pliers
J 8433 Puller Set
J 37825 Puller Plate Assembly
J 37827 Puller Pilot
J 37828 Puller Fingers
J 37872 Spanner Wrench
Removing The Nut
-
Insert the two pins of the J 37872 into any two threaded holes of the clutch front plate. Hold the clutch plate stationary.
1. Hex nut using a 14 mm socket.
Removing The Clutch Plate
2. Clutch front plate using J 37825.
-
Align the puller center bolt to the compressor shaft.
-
Thumb tighten the three puller bolts into the threaded holes.
-
Turn the center bolt to the right with the socket wrench until the front plate is loosened.
