S15/T15 Jimmy 2WD V6-262 4.3L VIN Z (1994)
1. Relay rod ball stud nut at pitman arm. Do not reuse the nut.
2. Relay rod ball stud from pitman arm using J 24319-01.
3. Pitman arm nut and washer.
^
Mark the pitman arm and the pitman shaft. This will permit proper alignment at assembly.
NOTICE: Do not hammer on pitman arm, pitman shaft, or puller. Damage to pitman arm or steering gear may result.
4. Pitman arm. Use J 6632-01 or J 29107.
INSPECT
^
Ball stud threads for damage.
^
Ball stud seals for excessive wear.
CLEAN
^
Threads on the ball stud.
Steering Linkage (2 Wheel Drive)
INSTALL OR CONNECT
TOOLS REQUIRED:
^
J 29193 Steering Linkage Installer (12 mm).
1. Pitman arm on the pitman shaft. Line up the marks made at removal.
2. Pitman arm washer and nut.
TIGHTEN
^
Pitman arm nut to 250 Nm (185 lbs. ft.).
3. Relay rod ball stud to the pitman arm. Make sure the seal is on the stud.
^
Tighten J 29193 or J 29194 to 62 Nm (48 lbs. ft.) to seat the tapers. Remove the tool.
