S15/T15 Jimmy 2WD V6-262 4.3L VIN Z (1994)
^
Tighten screws (62) to 3.7 Nm (33 lb.in.).
6. Support assembly (63) and screw (60).
TIGHTEN
^
Tighten screw (60) to 8.8 Nm (77 lb.in.).
7. Actuator assembly (76) to groove in housing support assembly (63).
8. Column shaft assembly (55) to jacket assembly (73).
^
Lubricate with lithium grease.
9. Tilt lever.
Installing Column Housing To Housing Support
10. Steering column housing assembly (30) to column.
Actuator Assembly To Actuator Rack Installed
A. Position column housing (30) and align switch actuator rack (44) with pin on end of ignition switch actuator assembly (76).
B. Pull back on tilt lever, pushing column housing assembly (30) onto column housing support assembly (63).
C. Release tilt lever to lock shoes (34) and (35) onto dowel pins.
D. Remove tilt lever.
11. Pivot pins (39).
A. Lubricate with lithium grease.
B. Press pin until firmly seated, two places.
12. Adapter & bearing assembly (85).
^
Lubricate inner surface of bearing (85) with lithium grease.
13. Bearing adapter retainer (86).
14. Lower bearing adapter clip (87).
15. Do steps 1 through 13 "INSTALL OR CONNECT", for "HOUSING COVER".
16. Do steps 1 through 20, "INSTALL OR CONNECT", for "UPPER COLUMN".
17. Do all steps, "IGNITION SWITCH ASSEMBLY", "INSTALL OR CONNECT", for "LOWER COLUMN".
Steering Column Housing Cover Components - Column Shift
HOUSING COVER
