S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
17. Grind the underside of the existing roof.
18. Grind the top surface of the D-Ring.
19. Grind the TOP and BOTTOM of the service part mating edges to bare metal.
-
Dry fit the new part to the body.
-
While the part is attached to the body, mark the bottom side of the new part in order to determine which area needs to be ground to bare metal.
-
Remove the part from the body and grind the bottom side of the part to bare metal.
-
Thinly coat all bare sheet metal on the bottom side of the part with adhesive.
Important: Pre-fit the service part to ensure proper alignment.
