S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
There may be a void in the body seam below the window. Refer to the arrow in the illustration.
Correction
Clean, dry and reseal with one of the sealers listed.
Condition 10
Rear floor wet.
Cause A
There may be a void in the roof seam sealer.
Cause B
There may be a void in the urethane around the back glass (Pickup).
Cause C
The vent window may have a bent flange or it may be mispositioned.
Correction A
For utilities, test for a void using air forced from inside the vehicle while spraying soapy water along the roof seam. Air can be forced up the "D" pillar
behind the trim panel, or through the top weatherstrip attaching hole in the "B" pillar for two door utilities and behind the trim on the "C" pillar for four
door utilities. Refer to the illustration shown. Clean, dry and reseal with one of the sealers listed.
