S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
7. Connect the brake hose to the caliper (RWD).
NOTICE: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
^
Tighten the brake hose fitting to 54 Nm (40 ft. lbs.).
8. Measure the clearance between the caliper and the steering knuckle.
8.1. Measure each end of the caliper individually.
8.2. Add the two measurements together. The total measurement should be 0.26 - 0.60 mm (0.010 - 0.024 in).
9. Connect the ABS sensor wire, if removed.
^
Tighten the ABS sensor wire to 17 Nm (13 ft. lbs.).
10. Install the tire and wheel assembly. Refer to Wheel Installation.
11. Lower the vehicle and remove the safety stands.
Brake Caliper Replacement (Front Dual Piston)
Brake Caliper Replacement (Front Dual Piston)
Removal
1. Remove two-thirds of the brake fluid from the master cylinder reservoir.
2. Raise the vehicle and support the vehicle with proper safety stands.
3. Remove the tire and wheel assembly.
