S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
6. Install the EVAP canister purge solenoid valve.
7. Connect the vacuum brake booster hose.
8. Connect the vacuum hose to the intake manifold, if equipped with A/C.
9. Install the PCV hose assembly to the intake manifold and the valve rocker arm cover.
10. Install the fuel supply and return pipes to the rear of the intake manifold.
11. Install the exhaust gas recirculation (EGR) valve inlet pipe to the intake manifold and the exhaust manifold.
11.1.
Tighten the EGR valve inlet pipe intake manifold nut to 25 Nm (18 ft. lbs.).
11.2.
Tighten the EGR valve inlet pipe exhaust manifold nut to 30 Nm (22 ft. lbs.).
11.3.
Tighten the EGR valve inlet pipe clamp bolt to 25 Nm (18 ft. lbs.).
IMPORTANT: In order to install the distributor for the correct engine timing, position the engine to number one cylinder top dead center.
