S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
Evaporator Core: Service and Repair
Automatic A/C
AIR CONDITIONING EVAPORATOR CORE REPLACEMENT
Tools Required
J 39400-A Halogen Leak Detector
REMOVAL PROCEDURE
1. Disconnect the underhood lamp electrical connector, if equipped.
2. Remove the hood.
3. Remove the PCM/VCM.
4. Remove the coolant recovery tank.
5. Disconnect the electrical connectors from the grille mounted lamps, if equipped.
6. Remove the right front headlamp assembly.
7. Remove the front bumper.
8. Remove the right wheelhouse panel.
9. Disconnect the radio antenna cable.
10. Disconnect the electrical connector for the horn.
11. Remove the right fender.
12. Remove the blower motor resistor.
13. Remove the accumulator.
14. Remove the evaporator tube.
15. Remove the evaporator and blower module heat shield mounting screws.
16. Remove the evaporator and blower module heat shield.
Important: Retain the evaporator and blower module heat shield mounting brackets for installation.
17. Remove the evaporator and blower module mounting bolts and nuts.
18. Remove the evaporator and blower module from the vehicle.
19. Remove the 6 retaining screws holding the evaporator case section to the blower section.