Jimmy 2WD V6-43L Manifold Pressure Sensor Diagrams
Manifold Pressure/Vacuum Sensor: Description and Operation
Manifold Absolute Pressure (MAP) Sensor
PURPOSE
The Manifold Absolute Pressure (MAP) sensor responds to changes in the intake manifold pressure. The pressure changes as a result of engine
load and speed. The map sensor converts this to a voltage output.
OPERATION
A closed throttle on engine coast down would produce a relatively low MAP output voltage. A wide open throttle would produce a high MAP
output voltage. This high output voltage is produced because the pressure inside the manifold is the same as outside the manifold. The MAP is
inversely proportional to what is measured on a vacuum gage. The MAP sensor is used for the following:
^
Altitude determination.
^
Ignition timing control.
^
Exhaust Gas Recirculation (EGR) diagnostic.
^
Speed density fuel management default.
When the VCM detects a malfunction in the MAP sensor circuit, the following Diagnostic Trouble Code (DTC)s will set:
^
DTC P0106 circuit performance.
^
DTC P0107 circuit low.
^
DTC P0108 circuit high.
^
DTC P1106 intermittent circuit high.
^
DTC P1107 intermittent circuit low.
Refer to System Diagnosis / Diagnostic Tables for testing information.
